8/28/2023 0 Comments Prusa slicer z hop![]() Duet Web Control will parse and read accurate statistics now.Script updates the comments with usage/runtime statistics generated by PrusaSlicer.Added filament usage statistics aggregation.Now if the prime tower is padded at the end of Tool printing process, printer will not do an extra move to the previous position Changed the behaviour of the PrimeTower generation.Script now cleans up the heated bed gcode from PS (M140 and M190 commands) and adds the M140 and M190Ĭommands to set the temperature that is MAX of all heated bed temperatures of filaments in use PrusaSlicer would assign sometimes assign wrong temperature to the heated bed. Fixed the firmware G10 retraction detection to work properly when using G10 commands for temperature setup.Replaced the M104 gcode (deprecated) generation with the G10.Fixed faulty extrusion formula for the Prime Tower generation.Added compatibility with the new RepRapFirmware G-code flavour in PrusaSlicer 2.3, Supported flavours now are RepRapFirmware and RepRap/Sprinter.Tested compatibility with Prusa Slicer 2.3.This would mean that tools wouldn't be pre-heated untill first activation. This is because G10 command doesn't switch the heater from Off->Standby and there no explicit G-code to do that. Rollback of the G10 temperature contol back to M104 (for initial setup).Merlin M900, mapping of the fan ranges etc.) Validation/stripping of the GCode (i.e.Smart Active/Idle tool-head temperature management.The script includes the following enhancements: This is a post processing script for PrusaSlicer for tool-changing/IDEX multu-extruder setupsĮ3D toolchanger with Duet 3 board running RR3.01RC4 firmware with 4 tools
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |